Rip Fence Assembly w/Resaw for 14” Bandsaw - 708718R  Product Reviews

"I recently purchased this item and installed it on my 95' model Jet saw and it fit just fine. No mods necessary. Nice piece of hardware."

"I purchased this fence system & love it. It installed very easily in about 30 minutes. I took care to get it leveled up well & to have the fence sit about 1/64" above the saw table so it doesn't chatter when I move it. This fence is vey much like my table saw Biesmeyer fence, just smaller. Much better than the melamine covered particle board table & fence system I had purchased."

"I bought this fence thinking it would fit my 14" Jet band saw, since the description said it would fit most. Unfortunately, when I started to install I quickly found out that it would not. My band saw, as I found out later, is a bit too old (around 8-10 years)for this fence. There is was no guidance available to make it fit my table either. Basically the engineers at Jet said it was incompatible. It would have been nice to know that before I made the purchase."

"I have a Ridgid 14" bandsaw, and while putting this fence on the saw was no big deal (went on pretty easily, altho I did have to shim out the rails), the clamping pad on the fence itself fell off after just a few weeks. I'm talking about the little piece of plastic that was POORLY glued on the clamp of the fence itself. It fell off repeatedly, even after I glued it back on repeatedly with Gorilla Glue, hot glue, epoxy, Superglue, you name it, I tried it. I finally gave up and got the Rockler bandsaw table and fence combo. Now I have a much bigger table and a fence that locks down securely in a T track with no wobble, not to mention a circle cutting guide and a resaw fence. Don't waste your money, go straight for the Rockler table and fence system."